2 Rows Of Pits Side Draft Paint Booth For Painting And Drying Bus
- Professional manufacture Bus spray booth
- Best price and after-sale service
- Installation spray booth for the abroad is approved
- suitable for painting truck or Bus
- Advantages of combined paint spraying
Detail Specification WD-15-5
15000× 5000× 5000 mm(L× W× H)
15144× 6896× 5600 mm(L× W× H)
2 rows of pits in the ground for exhaust, dimension of each pit is
13850× 760mm(L× W), with galvanized grilles made by twisted steel
and flat bar above.
Folding door, 4-folds, 4000× 4500mm(W× H), galvanized steel frame,
with polystyrene(EPS) inside, colour: blue.
2 units, 800× 2000 mm (WXH), colour: white.
Profiled bar beams in the roof to strengthen the room body; wall
thickness: 70mm, width: 1150mm, tongue and groove structure,0.476mm
colour steel with polystyrene(EPS) insulation inside, colour:
Ceiling Lights: 18Units× 4Pcs=72Pcs× 36W, with electronic ballasts.
Side Lights: 22Units× 4Pcs=88Pcs× 36W, with electronic ballasts,
up and down setting installation.
Intake from side upper direction, exhaust from back upper
quadrate steel frame, outside is white coated steel, inside is
steel, filled with heat preservation material in the middle.
Intake and exhaust system
2 units, in total 4× 7.5KWdouble-intake centrifugal fans for
model YDW4.5M, air capacity is 21000m 3 /h for each fan;
2× 11KW double-intake centrifugal fans for exhaust, with
belt-drive, model TAE-710H, air capacity is 36000m3/h for
each fan. Equip manual dampers for exhaust air.
2 units RIELLO RG5S diesel burners, heating productivity: 520000
Kcal/h, stainless steel heat exchanger, pneumatic dampers actuate
from spraying to baking cycle.
Pre-filter, high efficiency filter(ceiling filter), exhaust
activated carbon filter.
50mm thick EPS heat preservation panels.
Spraying, heat spraying, baking, time setting, lighting switch,
indicator, thermostat, power supply switch, emergency stop, ampere
meter,voltmeter, hours meter, temperature limit controller,
gauge. Exhaust star-delta motor start.
Spray Booth Technical Parameters WD-15-5
Width of Entrance
Height of Entrance
Escape door dimension
Intake air fan capacity
Exhaust air fan capacity
Free air speed
Frequency of Air Exchange
Maximum working temperature
Max. Heating Productivity
Air Filter Efficiency
Product in factory
Spray booth comonent part
WINDAN SPRAY BOOTH IN THE EXHIBITION
All electron component are guaranteed for 12 months from the date
of receipt.During warranty damage
are free replacement.Customer bear the expense of freightage.
Something about the spray booth
Improper Operation of the Spray Booth System may cause the
· Danger of fire or explosion because of :
- The chemical imbalance in the working area during the painting
phase due to not turning the unit on, operating in the wrong phase,
or clogging of the filters.
- When enough particulate accumulates in the booth, there is a danger
of spontaneous combustion.
- due to inadequate, or total lack of ventilation during the
operating phases of the booth (painting -flash-off -bake)
- due to an improperly operating burner.
Atmospheric imbalance in the environment caused by the solids
emission and particles of the
unintended painting substance due to the insufficient operation of
the exhaust paint arrest or filters.
An excessive buildup of over spray on the floor, in the duct work,
the heating system, or the pit,
should be prevented. It could ignite spontaneously or from some
equipment malfunction types.
Welcome to contact us for Quotation